Krag Collectors Association Forum Archive | |
General >> Older threads >> East Taylor LLC Parts of Antiques handguards
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1359696810 Message started by Thomassen on Feb 1st, 2013 at 5:33am |
Title: East Taylor LLC Parts of Antiques handguards Post by Thomassen on Feb 1st, 2013 at 5:33am
Has anyone used these krag handguards for a restoration? They list at $65. Significantly cheaper than those at S and S ($90). I have hear about some handguards that use brass rivets.
|
Title: Re: East Taylor LLC Parts of Antiques handguards Post by butlersrangers on Feb 1st, 2013 at 2:11pm
I've used one of their 1898/1902 Krag hand-guards and it was real decent with steel rivets. It only required a 1/8" trimming because it covered too much of the receiver ring. Another member recently bought the same hand-guard and the sight opening was real sloppy. Luck of the draw? I've also used one of their Krag forends to restore a cut down 1898 Krag rifle stock. It required slight trimming, front and rear, for correct length. But was nice walnut and accurately machined.
|
Title: Re: East Taylor LLC Parts of Antiques handguards Post by Greg H. in Va. on Feb 24th, 2013 at 3:53am
I got one for my recently acquired 1898 Krag rifle, and it was a perfect fit to the rifle and the 1902 sight I got for it.
|
Title: Re: East Taylor LLC Parts of Antiques handguards Post by Thomassen on Feb 24th, 2013 at 4:13am
I received one this week and am returning it. The sight cut out was over sized.
|
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2025. All Rights Reserved. |