Krag Collectors Association Forum Archive

Krag Collectors Association Forum Archive
General >> Ammunition, reloading, shooting, etc >> Contemplating buying a bullet mould http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1370911358 Message started by butlersrangers on Jun 11^th, 2013 at 12:42am

Title: Re: Contemplating buying a bullet mould
Post by gunboat57 on Jun 11^th, 2013 at 2:04am

Parashooter, not to derail the flow of this thread, but did that bullet in your picture sized to .312 and fired in a .303/.313 barrel show symptoms of leading when fired for real, not a squib load? Will the gas check keep it from leading even if the bullet is not .001" over groove diameter?