Krag Collectors Association Forum Archive | |
Firearms >> U.S. Military Krags >> Accuracy Question/ Point of Impact
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1467340628 Message started by Rick H. on Jul 1st, 2016 at 2:37am |
Title: Re: Accuracy Question/ Point of Impact Post by butlersrangers on Jul 1st, 2016 at 3:52am
Trigger guard screw tension or torque may be the issue on some Krags.
With barrel-bands in place, the front guard screw should be tightened first and quite tight. The rear guard screw should then be installed and just made snug. If the rear screw is too tight, it levers the barrel upward off the bottom of the stock's barrel channel. |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |