Krag Collectors Association Forum Archive | |
Firearms >> U.S. Military Krags >> Accuracy Question/ Point of Impact
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1467340628 Message started by Rick H. on Jul 1st, 2016 at 2:37am |
Title: Re: Accuracy Question/ Point of Impact Post by Rick H. on Jul 1st, 2016 at 12:57pm
Thanks for the replies gentlemen. I have worked on a number of 03's and 03A3's but they are vastly different in regards to barrel pressure etc. Can I assume that I should have just a slight amount of vertical barrel movement when all is tight? I am contemplating taking the front band off and leaving the rear band in place, then shooting the rifle to see what the results will be before I do anything else. I clearance the front barrel bands on 03 and 03A3's that I work on so I can just see light around the barrel and I have pretty good results with those so I am leaning towards doing the same with the Krag. I must say the suggestion to tighten the action screws a specific way is interesting also. Thanks again for the ideas!
Rick H. |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |