Krag Collectors Association Forum Archive
General >> Ammunition, reloading, shooting, etc >> Full Length Sizing vs. Neck Sizing
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1476579667

Message started by Stretch32 on Oct 16th, 2016 at 1:01am

Title: Re: Full Length Sizing vs. Neck Sizing
Post by Stretch32 on Oct 19th, 2016 at 9:18pm
Paul,

Thanks for the heads up, I appreciate it.

Sorry for the slight off-topic but I'm only looking for pulled M2 ball since I want to load as close to original spec as possible much like my Krag.

I have an interest in old military rifles in large part due to the history. Because of this, I'd like to load rounds to original USGI spec whenever possible to shoot them as originally intended.

With that, if I was going to shoot in a completion I'd definitely like to load up the most accurate cartridge possible within the rules. At this point though I'm just plinking hence the original loads I'm striving for.

Stretch   

Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0!
YaBB Forum Software © 2000-2024. All Rights Reserved.