Krag Collectors Association Forum Archive | |
General >> Ammunition, reloading, shooting, etc >> krag side plate screw
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1478550514 Message started by porthos on Nov 7th, 2016 at 8:28pm |
Title: Re: krag side plate screw Post by butlersrangers on Nov 14th, 2016 at 6:32pm
A longer Krag side-plate screw can be improvised by using a reproduction 1903 Springfield rear swivel screw or front stacking swivel screw.
These commonly available screws use the same 26 TPI thread that the Krag side-plate screw utilizes. All that is required is shortening the 1903 swivel screw, reducing the diameter of some of the shank above the threads, and slightly reducing the screw-head diameter (if necessary). The 'reduction in diameter' can be done with small files, while turning the 1903 screw in a drill 'Chuck'. (This is best done before shortening the screw). |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |