Krag Collectors Association Forum Archive | |
Firearms >> Sporterized and unofficial modified Krags >> Removing a front sight
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1512457909 Message started by timmholt on Dec 5th, 2017 at 7:11am |
Title: Re: Removing a front sight Post by timmholt on Dec 5th, 2017 at 6:03pm
Thanks FredC
I actually was looking at the Springfield front sight approach as the simplest solution, or possibly one of the reproductions soldered on if I could mill the bottom to match the curvature of the barrel. I do have access to a mill - sort of. It's at work in an open shop, but the (very very large high tech) company has a "no guns on site" rule. I could definitely take in a site base and do a little work on it and not cross that line, but taking in a barrel I'm not sure about. It's crossed my mind just to mill up my own replacement site base like the one attached to this post, and as mentioned, solder it on. I just would need the dimensions of one. Or yea, just buy a replacement - they aren't that much in a way. |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |