Krag Collectors Association Forum Archive | |
Firearms >> U.S. Military Krags >> New member with a Krag project.
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1519523268 Message started by milsurpshooter on Feb 25th, 2018 at 1:47am |
Title: Re: New member with a Krag project. Post by butlersrangers on Mar 14th, 2018 at 3:54am
IMHO - With use these parts will 'wear in', but, they should not have to.
It would be interesting to inspect the OP's Krag and note possible reasons for tight headspace. IIRC - This Krag came with a bolt that had the firing-pin cut and the firing pin hole in the bolt face welded up. OP's picture of barrel breech shows possible roughness. |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |