Krag Collectors Association Forum Archive | |
Firearms >> U.S. Military Krags >> New member with a Krag project.
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1519523268 Message started by milsurpshooter on Feb 25th, 2018 at 1:47am |
Title: Re: New member with a Krag project. Post by Parashooter on Mar 20th, 2018 at 9:46pm milsurpshooter wrote on Mar 20th, 2018 at 1:08pm:
Forster will sell you one for $36. See (You need to Login; Image file shows Forster specs. You could just stone off .0015" from your .0655" gauge. Rub it in an orbital pattern on a fresh sheet of oiled 400-grit wet/dry paper laid on a hard, flat surface. Shouldn't take long to remove .0015". Being cheap, I'd find a case with a .060" rim and add a shim cut from an aluminum beverage can (typically about .004"). If that combination goes, you should be OK with any cases that are within spec. None of this is necessary unless you're having bolt-closing problems with the cases you use - almost all of which likely have rims under .062" thick. FWIW, back when Krags were dirt cheap and gunsmiths knew them well, it was common practice to lap in the front lug far enough to let the guide rib contact the receiver (Norsk style, about .008") when fitting a custom barrel in some wildcat chambering. Lapping yours a couple of thousandths shouldn't be a problem. |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |