Krag Collectors Association Forum Archive | |
General >> Ammunition, reloading, shooting, etc >> Chargers, or lack there of...
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1527253239 Message started by psteinmayer on May 25th, 2018 at 1:00pm |
Title: Re: Chargers, or lack there of... Post by madsenshooter on May 25th, 2018 at 5:57pm
Time is something I have a lot of. Not much in the way of brass sheet though. Printing plate with a thickness of .011-.015 will work, but it likely depends on the alloy they're made of. .011 is flimsy and would have to be handled carefully. One charger I made from it works, but the tabs may not last long. I got some .014 aluminum sheet off ebay that will not work, it'll break at a tight bend. I never did figure out how to size Parashooter's template right without wasting a lot of paper and ink so that I could make use of it. It was easier for me to closely copy Paul's already made charger.
|
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |