Krag Collectors Association Forum Archive | |
Firearms >> U.S. Military Krags >> Krag loading gate-follower question
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1533688187 Message started by Baltimoreed on Aug 8th, 2018 at 12:29am |
Title: Re: Krag loading gate-follower question Post by Baltimoreed on Aug 11th, 2018 at 1:44am
It measures 9/16 inch at the point you indicated. But why is my gate opening so wide? Time to take it apart. I just swapped out the ?gate and hinge bar pin with another gate and pin that I had. It’s not as pretty but doesn’t seem to open any where near as far as the original one. Opens like the gate on my scout. Other than a whole lotta crud on the original gate, pin, spring etc I didn’t see anything broken. Both of the squarish gate studs looked the same, I didn’t think to mic them. Must have been wear on the original gate. Looks good now. Thanks, BE
|
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |