Krag Collectors Association Forum Archive | |
Firearms >> Sporterized and unofficial modified Krags >> New member - new krag
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1535524744 Message started by quietriot on Aug 29th, 2018 at 6:39am |
Title: Re: New member - new krag Post by butlersrangers on Sep 2nd, 2018 at 10:57pm
'quietriot':
Your barrel is an original U.S. Krag carbine barrel, as evidenced by the quality of the front-sight attachment. If your front blade is a model 1896 or 1898 carbine blade, the "C" is normally on the left-side and positioned low and out of sight. The blade was intended to work with the model 1896 carbine rear-sight. The model 1899 blade is taller and has the "C" normally on the right-side, in plain view. The blade was intended to work with the 1901 and 1902 carbine rear-sights. A replacement Redfield 102-K "side-plate" screw can be made from Krag and 1903 Springfield barrel-band/sling-swivel screws or stacking-swivel screws. (It is best to alter reproduction screws. The thread is unusual - .187"X 26TPI. You won't find these at ACO). Reproduction screws appear on ebay or can be purchased from S&S Firearms, Glendale, N.Y. Their catalog can be viewed online. Pacific K-1 sights show up from time to time on ebay. Both Redfield and Pacific 'no-drill' sights work fine. Because they usually sit higher than issue Krag rear-sights, a rifle blade .413" tall, (out of its base), is often required. |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |