The following is my std practice for all rifle brass:
1.      Vibratory cleaned with walnut pieces.  Sometimes adding a dose brass polish.
2.      Brush the inside of case necks with mica. (Lyman prep station)
3.      Full length resize the case.  I use Imperial Wax.
4.      Back to the vibratory cleaner for a few minutes to remove lube.
5.      Cases are trimmed as needed.  I usually run all cases thru a trimmer.  Rather than measuring each to determine if trimming is needed. 
6.      Flash holes inspected for any walnut hull pieces.  Ice pick to remove as needed.
7.      Primer pockets cleaned and inside/outside case mouth chamfering done using a Lyman prep station.    (You need to Login