Krag Collectors Association Forum Archive | |
General >> Ammunition, reloading, shooting, etc >> Partial Full Length Sizing New Brass
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1554083935 Message started by Playapat on Apr 1st, 2019 at 1:58am |
Title: Re: Partial Full Length Sizing New Brass Post by psteinmayer on Apr 1st, 2019 at 6:40pm
If you do neck-size... remember to keep your brass assigned to the rifle it was shot in. I always FL size new brass, and then neck size only afterward. I also anneal often. I've achieved more than 20 reloads on some of my older R-P brass... but I am occasionally getting neck cracks (at which point they go into the scrap can).
Remember... take care of your brass and it will take care of you! |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |