Krag Collectors Association Forum Archive | |
Firearms >> U.S. Military Krags >> 32 Steps - in manufacture of U.S. Krag barrel
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1555548932 Message started by butlersrangers on Apr 18th, 2019 at 12:55am |
Title: Re: 32 Steps - in manufacture of U.S. Krag barrel Post by Knute1 on Apr 20th, 2019 at 4:13am
Here are (4) video clips of a Pratt & Whitney Sine Bar Rifling Machine circa 1900 (No. 2?) running. It sure must have been loud with a room full of these running. I'm not sure if they had it fully set up. When the rifling tool reaches the end of its stroke (left end) it is suppose to toggle an indexer bar, but it didn't appear to be activated. Appears they had an old section of an octagon muzzleloader barrel set up just to initially play with the machine.
Clip 1: (You need to Login Clip 2: (You need to Login Clip3 : (You need to Login Clip 4: (You need to Login |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |