Krag Collectors Association Forum Archive | |
Firearms >> U.S. Military Krags >> Front sight
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1559096749 Message started by Jim3040 on May 29th, 2019 at 2:25am |
Title: Re: Front sight Post by butlersrangers on May 29th, 2019 at 3:26am
The front-sight Pin is slightly tapered and should be driven from left to right.
Pin diameter is approximately .061 to .063". Pin length is approximately .248 to .255". A 'drift punch' tip area should be .060" or less in diameter. I made a 'punch' from a cheap 'all metal' Jeweler's screwdriver, by grinding the tip 'flat'. I use a plastic or copper mallet with my improvised 'punch'. Barrel and sight-base are supported on a wood block with a hole for Pin to move into. (I lay the barreled-action on a bench, resting on the flat side of the magazine-gate. The barrel-muzzle is supported by the wood block and is relatively level). It does not require much force. The Pin is relatively soft. |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |