Krag Collectors Association Forum Archive

Krag Collectors Association Forum Archive
General >> Ammunition, reloading, shooting, etc >> Krag Bore Size Question http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1572879925 Message started by Texas10 on Nov 4^th, 2019 at 3:05pm

Title: Re: Krag Bore Size Question
Post by Parashooter on Dec 21^st, 2019 at 5:23am

Texas10 wrote on Dec 21^st, 2019 at 1:53am:

Ok now, that was just too easy! OO buck, an Oak dowel, and a stiff cleaning rod perhaps?

What are the dimensions I'm looking for? Groove and bore? . . .

Bamboo chopstick makes handy starter. Best is a brass rod about 7mm.

Nominal US Krag barrel is .300"x.308" - some a bit larger, few smaller.