Krag Collectors Association Forum Archive | |
General >> Ammunition, reloading, shooting, etc >> Krag Bore Size Question
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1572879925 Message started by Texas10 on Nov 4th, 2019 at 3:05pm |
Title: Re: Krag Bore Size Question Post by FredC on Nov 4th, 2019 at 4:07pm
The first Krags had an issue with bore size variation. My recollection is not perfect on this but I think most were too large and many of these work better with cast bullet sized a little on the large size.
Later Krags should have been held to a tighter tolerance, and should have a .300 bore and .308 land to land measurement just like your Shilen. No copper fouling buildup? |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |