Hello FredC,
Thank you for your insight and the photo of your trigger fabrication. That was mighty fine work you did. I recall your comment that you did it 40-some years ago. My work on my trigger took place when I was working at a gunsmithing school . . . Hmmm. Over 40 years ago. My, how time flies when we are busy living life. I don’t recall any particular problems with the job but as far as engagement goes, I was then as now aware of the delicacy and concern regarding creating an unsafe condition. I guess you would have to shoot it to see what I achieved with both screws. Engagement is solid, release is smooth but firm. I should measure the trigger pull to see what it takes to release.

It’s not ‘jumpy’ or scary. It breaks clean and the over travel screw has not caused any interference with release. I understand your suggestion regarding a fixed screw but at least with the present set-up it is easy to adjust back if it seems necessary. As to looks, I am at peace with having a .30 cal shooter of modest yet effective performance. Below I show my latest find - a m1896 I found at a local gun show. Bolt & bore are bright & clean.

Be well and thank you. Rick

---