Krag Collectors Association Forum Archive
Firearms >> U.S. Military Krags >> Brass insert riveted into magazine? CMP purchased
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1581301852

Message started by fatdog on Feb 10th, 2020 at 2:30am

Title: Re: Brass insert riveted into magazine? CMP purchased
Post by butlersrangers on Feb 10th, 2020 at 4:26pm
Good point Fred, it could be.

I suspect this brass device was to feed .30-40 blank cartridges, but ....

He needs to visually check the chamber to make sure if it has not been altered.

If there is anything suspicious, a 'chamber cast should be done.

Here is a photo, (that a fellow KCA member posted years ago), of a .30-40 cartridge-case fired in a chamber crudely altered to accept .30-06 blanks:
chamber_problem_004.jpg ( 90 KB | 0 Downloads )

Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0!
YaBB Forum Software © 2000-2024. All Rights Reserved.