my friend has a mannlicher steyr M95/34 carbine in 8x56R that used to be his father's(he passed away last year). since he doesn't handload and 8x56R is not on the shelf of every walmart, he wants to sell it. i'll look it over, either this weekend or the next, and i'll buy it or just give him a wave and smile and say "no thank you".

the 8x57R isn't a favorite of mine(bore runs .329-.340"), but i think i could rebore it to 35-40 krag and put on an old aperture sight. then i'll have another 35 cal bore!!! my questions is, has anybody done this? what do you think about it? what do you do with 8x56R stripper clips to make into 35-40 krag stripper clips?

:Dno, i don't have any pictures of it. i'll just have to wait and see. ;D

How will you handle the ~.040" oversize chamber diameter?

A buddy of mine has converted them into both .45-70 and .30-40. I **believe** both required a new barrel.

The 8x56R is a fun cartridge and components are available. Hornady produces a soft point and Privi makes both FMJ and cases. Lee makes dies.

Parashooter wrote on May 14^th, 2020 at 5:56am:

How will you handle the ~.040" oversize chamber diameter?

i finally got around to comparing both cartridges and the diameter of the krag is too small. so i'll rebarrel it or stay the same.

my friend showed up and he wants a price that is beyond my capabilities, so i said no, thank you.

i noticed right off the bat, the stock was cracked(s), yes, plural. it didn't have a handgaurd or the two bands. the action and barrel are rusty(give them a bath, scrub bath, scrub........until it needs reblued. and while your at, bathe the magazine housing too. the bore looked fine(?), nothing better than elbow grease. he didn't have enbloc clips, so i'll take his word it function. i should have field strip it, but i quit going it over when he told the price.