Krag Collectors Association Forum Archive | |
General >> Ammunition, reloading, shooting, etc >> Bench rest shoulder - ouch!
http://www.kragcollectorsassociation.org/cgi-bin/yabb2/YaBB.pl?num=1594445494 Message started by RicKrager on Jul 11th, 2020 at 5:31am |
Title: Re: Bench rest shoulder - ouch! Post by RicKrager on Jul 12th, 2020 at 3:52pm
Butlersrangers,
Thanks for the information regarding the screws and barrel band. Yesterday I pulled the action for the first time and found the rear trigger guard screw the tightest. Since I had the action out i cleaned the metal bits w/0000 steel wool and oil, finding few areas of concern. Now the metal bits have had a bit of oil and wipe down. On the wood under the magazine I found a stamped in E. As this is sporterized there are no original marks on the rest of the stock. I appreciate your information for padding at the bench. I was using a padded forward rest, left hand supporting the butt, right elbow at 90°. If I need to check zero off the bench again I will try an approach more as suggested on these pages. Thanks to all for their responses. |
Krag Collectors Association Forum Archive » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |