Page Index Toggle Pages: 1 Send TopicPrint
WTB: Mills belt part (Read 1464 times)
Tom Butts
KCA Forum Admin
KCA Official Member

Krag enthusiast!

Posts: 347
Location: New York State
Joined: Apr 1st, 2002
Gender: Male
WTB: Mills belt part
Feb 22nd, 2012 at 1:40am
I need a part for a Krag Mills belt.  Mine is missing one brass keeper. (if thats the correct term?) Its the brass part just over 1/2" wide with two tabs on each end that bend over the belt to keep the adjustment in place.  It is very slightly rounded in cross section.

Brad Foust <>
Back to top
IP Logged
Page Index Toggle Pages: 1
Send TopicPrint
Bookmarks: Digg Facebook Google Google+ Linked in reddit StumbleUpon Twitter Yahoo
  « Board Index ‹ Board  ^Top