(UTC)
(Moderators: Tom Butts, Ned Butts, KCA Forum Admin)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Redfield 102-K mounting screw (Read 1174 times)
butlersrangers
KCA Forum Member
*
Offline


Krag Enthusiast!

Posts: 6330
Location: Michigan Bi-Peninsular&Proud
Joined: Oct 7th, 2009
Redfield 102-K mounting screw
Apr 29th, 2016 at 7:16pm
Print Post  
As far as I know, no one currently makes a mounting screw for the Redfield 102-K and 70-K ('No-Drill') receiver-sights.

The Krag side-plate screw has 26 threads per inch.
(FWIW - .187"X 26 - in the Frankford Arsenal 1902 tap & die sets).

The same thread is used on the Krag and '03 Springfield rear barrel-band screws and stacking-swivel screws. (The tips of these screws are often 'mushroomed'  on original screws).

I have been able to make some replacement 'Redfield' screws by shortening replica '03 Springfield stacking-swivel screws that I bought on eBay a couple of years ago.
  
Back to top
 
IP Logged
 
S.B.
KCA Forum Member
*
Offline



Posts: 65
Location: Central Illinois
Joined: May 4th, 2003
Gender: Male
Re: Redfield 102-K mounting screw
Reply #1 - May 1st, 2016 at 3:05pm
Print Post  
Thank you, I wasn't informed of your PM and this helps immensely. I should of known, check here first.
thank you, very much, Steve
  
The Original Point and Click Interface was a Smith & Wesson
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›