gtbee80
KCA Forum Member
Offline
Krag Enthusiast!
Posts: 13 Location: Atlanta, GA Joined: May 8 th, 2017 Gender:
|
Re: Safety Selector - inserting plunger in groove
Reply #2 - Nov 29th, 2018 at 1:04am
|
Print Post
|
OK, thanks. Followed your suggestions, used jewelers driver & managed to finally get it. Was originally holding it all in my hands too but finally put the flat faces of the bolt sleeve in a vice (cushioned) to get max leverage on the selector & plunger, could never really get the plunger far enough in to just push the selector on by hand but got it close enough to tap gently with a rubber mallet & nudge it over the lip.
The project piece is on the right. Appreciate it!
|